PalmOne Power To Go

• Recharges handheld 1-2 times, depending on model
• Charge status LED
• Pass-through Universal Connector allows handheld and Power To Go to recharge together in a cradle or travel charger
• Compatible with Palm Tungsten T, Tungsten W, Zire 71, m500 Series, i705, m130 handhelds

As a heavy Palm user, I've found PalmOne's Power To Go quite handy. When its attached, it 1) charges my Palm and 2) is still usable on any Palm keyboard. It can 3) also be charged in a cradle and 4) be synced while its linked. (Hey, that rhymes!) Its use is thus totally transparent.

The only thing that it won't do while attached is fit in my T3's hard case, which isn't a very big deal.

I use my Power To Go mainly at work. When I'm checking email or voice mail at my desk, I'll normally keep the Power To Go unit attached to my Palm so that my T3 is always at its maximum charge in case I get pulled away to a long meeting (where I'll take notes using a keyboard with my PDA). When I'm gone, I'll leave the Power To Go unit in my cradle to juice it back up!

But if I'm going to a meeting which I know will put unusually high demands on my Palm then I'll take the Power To Go unit with me so I never need to worry that my T3 will ever run out of gas.

The Power To Go sled attaches by grabbing on to slots on the back of every Palm (which I never knew were there), so the connection is very positive and one that will not let go accidentally.

The Power To Go unit also has a light which, when lit, tells you that its charging your Palm. So, if it should ever go out then you'll know that you're running on your Palm's battery alone and that its time to recharge the sled.

If you're a heavy Palm user like me, PalmOne's Power To Go will allow your Palm to always stay in the game! (I've never felt more helpless than to be in a meeting with a dead Palm!) I highly recommend it!

Buy PalmOne Power To Go Now

Everyone seems to overlook the fact that these ALSO work with Palm Tungsten C's.

I have a Tungsten C and 2 of these units. I keep one Power To Go in my charger cradle at all times and carry the other with me everywhere I go. I swap them with each other and that way I always have the capacity to fully charge my Tungsten C at any time. The only reasons I don't leave it attached at all times is that the Tungsten C won't fit in my case with the unit attached and the user manual says not to.

I rely heavily on my Tungsten C for reference applications and journals at work as well as pleasure (game playing and LOTS of reading) and video, so it would spend a LOT of time on the charger cradle if not for these clever little buggers. I can get 1 full charge and another half to 3/4 charge out of one fully charged Power To Go unit with my Tungsten C. You can Hot Sync even while the Power To Go is attached (and even fully charge both Palm AND POwer To Go at the same time in the cradle).

My sister who doesn't use her Zire 31 nearly as much is frustrated that Power To Go won't work with her handheld and she has to either carry her charger cord with her or recharge her unit almost daily.

This unit is SO worth it if you rely on a fully charged handheld on a daily basis. I was just looking for these on the Palm site and they are no longer listed there, so I wonder if they will continue to manufacture them.

You'd be wise to get at least one while you can...and remember: THEY WORK WITH TUNGSTEN C, TOO!!

Read Best Reviews of PalmOne Power To Go Here

I bought this when I was flying from the states to Japan several times a year. If used carefully, I could get 2+ full recharges out of it. Still works great after two years.