- Plastic Housing To Fit Into Projector
- Easy Installation Require No Re-wiring
- 6-month Warranty
- 4,000 Hour Lamp Life
** UPDATE **
The lamp ended up having a problem of blinking on me.... I ordered one from Samsung direct and fixed the whole problem... so unfortunately the lamp only worked for a couple of months so I cannot recommend this lamp. Get it from samsung directly its about the same price and just as easy to install.
Buy Replace Lamp for Samsung TV BP96-00826A Now
I bought one these to replace a dimming lamp in my 50" Samsung DLP. I installed the lamp and after a few hours I started to notice a weird flickering in the picture. After a few more hours it got worse so I removed the lamp, reinstalled the old one and sent it back to Amazon for exchange. I got the replacement a few days later and installed it right away. Within a few minutes I noticed the same flicker as the previous one. So this time I boxed it up and sent it back for a refund. Between my experience, and the other review, all I can guess is that Amazon got a bad batch.Read Best Reviews of Replace Lamp for Samsung TV BP96-00826A Here
I replaced the bulb and ballast at the same time. It took me 5 minutes to swap it out and after a short warm-up time the TV was good as new!Thought I was pretty smart saving $35 over the Samsung replacement lamp, but this one worked fine for about four months then began blinking off every time the TV changed from a show to a commercial, from a commercial to a show, or from one commercial to another. And wouldn't you know it? Warranty is only three months. Guess I wasn't so smart.Everything seemed good when the package arrived. The item was packaged fine and the housing was well constructed. After installing the lamp the screen shut off in less than a minute and got progressively worse. I then thought there was another problem with my TV. Upon removing the lamp cover and overriding the safety switch I turned the unit on, then saw sparks from the end of the lamp where the wire was connected. Inspecting it closer and looking at the old bulb I noticed it wasn't the connection but the very end of the bulb had a small wire exposed. So instead of sending it back in I soldered the wire to the housing and reinstalled the lamp has been working fine ever since. I'd recommend you send it back if this happens to you unless your into electrical repair.

No comments:
Post a Comment